How to Set the Port on the SCUB/SCUN Board to the Uplink Port

Fakharany · Created Jan 23, 2019 12:59:15

You can run an electronic switch command on the SCUB control board to set the GE port on the board to an uplink port. The uplink port on the GIU board and the uplink port on the control board cannot be used for upstream transmission at the same time. You can use only either of them at a time.

If the SCUB control board is used, make sure that the current configuration of the system is already saved before running the electro-switch command. After this command is run, the system resets.

To set the port on the control board to the uplink port, run the electro-switch 0 location-0 command.
To set the port on the GIU board to the uplink port, run the electro-switch 0 location-1 command.
The SCUN control board can work with the GIU upstream board at the same time. In this case, the SCUN control board equals an upstream board in another GIU slot.

Precious · Created Dec 16, 2021 01:56:17

well answered about How to Set the Port on the SCUB/SCUN Board to the Uplink Port, Thanks

How to Set the Port on the SCUB/SCUN Board to the Uplink Port

Third Party’s Trade Secret

My Followers

Enterprise

Consumer

Corporate

Carriers

How to Set the Port on the SCUB/SCUN Board to the Uplink Port

Third Party’s Trade Secret

My Followers