How to Replace the Control Board of the MA5600T

Hi friend，

1. Save and back up the configuration file of the OLT.

Run the following command:

save

backup configuration

2. Replace the SCUL board with the SCUN board.

3. Upgrade the SCUN board to the version on the live network.

Run the following command:

load packet

4. After the board runs normally, upload the configuration file to the OLT.

Run the following command:

load configuration

5.Active configuration file

Run the following command:

active configuration

I hope useful to you

thanks

Hi friend hope video can help u:

The following principles apply for replacing a daughter board of the MA5600 control board:
1. The bandwidth can be upgraded, but cannot be downgraded. That is, an FE daughter board can be replaced with a GE daughter board, but a GE daughter board cannot be replaced with an FE daughter board.
Otherwise, the FE daughter board cannot be registered, and you have to clear the data and restart the device. 2. If the bandwidth remains unchanged, the number of ports on daughter boards can only increase. For example: A 2-port daughter board can be replaced with a 4-port daughter board, not the other way.

https://support.huawei.com/enterprisesearch/ebgSearch?newPbi=3#keyword=How to replace the control board of the MA5600?&lang=en&newsTypeId=&outside=0&productPath=1482605784817|1482605846394|18133&searchCount=2&searchType=searchAll&type=searchAll

https://www.pinterest.se/pin/571323902730466500/

Thanks!