Hello everyone today I will share the way how to replace satellite card of SRCU board in BITSV3.
Handling method
In the slide of the BITS V3 hardware design, solely the multidimensional language within the board is provided, without internal structure of the SRCU board. several engineers don't see this board and can't handle relevant issues.
To replace the board, perform the subsequent steps:
1. Use the board part as shown in Figure one to put in within the position as shown in Figure two. Insert
the board in socket properly. The board part is inserted within the SRCU or SOCU board.
2. decide 4PCS money supply x six screws (26010420). Use the 3.0kgf.cm screwdriver to tighten the sub board within the
positions of M15, M16, M17, and M18 within the stud. It ought to be noted that the Rb clock partition
board is put in on the aspect of the Rb clock, that is, M16 and M17 stud.
3. The GPS/GLONASS dual-satellite receive card is put in within the same manner as that of the Rb
clock partition board. A partition board isn't needed within the GPS/GLONASS dual-satellite card.
