Command:
Run the display board 0/0 command to check the PON port type and whether the
PON port is successfully registered with the OLT.
Command: Run the interface EPONNNI/GPONNNI 0/0 /1 command to enter the EPON
or GPON port mode.
Command: Run the display port state command to view the PON port status,
optical module type, and optical receive status.
Note: This command can be executed on the hardware of the new version. If
the command cannot be executed in earlier hardware versions, the command is
not supported.
How to query the status of a PON port on an MxU
Created: Jun 22, 2018 06:47:03
489
0
0
0
0
- x
- convention：
- Emotion(0)
Comment
Notice: To protect the legitimate rights and interests of you, the community, and third parties, do not release content that may bring legal risks to all parties, including but are not limited to the following:
- Politically sensitive content
- Content concerning pornography, gambling, and drug abuse
- Content that may disclose or infringe upon others ' commercial secrets, intellectual properties, including trade marks, copyrights, and patents, and personal privacy
