Question:
How to query the available bandwidth of a PON port?
Answer:
You can run the display port state command to query the available bandwidth (Kbps) of the port on theboard.
In the queried result, the parameter "Available bandwidth(Kbps) " indicates the available bandwidth of a port (remaining unassigned bandwidth and non-real-time available bandwidth).
huawei(config-if-gpon-)#display port state 0
----------------------------------------------------------------------------
Port Information
----------------------------------------------------------------------------
F/S/P
Port state Offline
Last down cause -
Last up time -
Last down time -
Port energy-saving flag No
xPON MAC chipset state Normal
Signal detect Normal
Available bandwidth(Kbps) 1241088
Illegal rogue ONT Inexistent This post was last edited by Majiangang at 2018-06-25 08:46.
How to query the available bandwidth of a GPON port
Created: May 24, 2018 03:50:57Latest reply: Sep 24, 2018 06:55:49
3337
3
2
0
0
The post is synchronized to: Hot Topics
- x
- convention：
- Emotion(0)
|
|
|
Comment
Notice: To protect the legitimate rights and interests of you, the community, and third parties, do not release content that may bring legal risks to all parties, including but are not limited to the following:
- Politically sensitive content
- Content concerning pornography, gambling, and drug abuse
- Content that may disclose or infringe upon others ' commercial secrets, intellectual properties, including trade marks, copyrights, and patents, and personal privacy
