Hello, everyone.
In this post, I would like to share with you how to connect to a NE using U2000 WEB LCT.
In order to connect the computer where the Web LCT is installed to an NE, you have to use a crossover or straight-through cable so that the Web LCT can directly manage the connected NE.
These 3 steps for this process:
1. Connect the crossover or straight-through cable to the Web LCT. One end of the cable should be connected to the network port of the computer.
2. Check the green indicator of the network adapter port of the computer and the indicators on the board that connect to the computer.
The indicator of the computer and the green "LINK' indicator on the board remain on. The orange "ACT" indicator on the board should blink.
3. Change the IP address of the computer being used to comission the NE so that the computer IP addres is on the same subnet as the default IP address of the NE.
For example 129.9.0.N, where N is an integer from 1 to 255.
That's all, I hope you like it.
Thank you!
