How to configure VCN540 entire network NTP configuration
Created: Jul 26, 2019 02:08:33Latest reply: Jul 26, 2019 02:19:11
491
2
0
0
0
Rewarded HiCoins：
0
(problem resolved)
- x
- convention：
- Emotion(0)
Featured Answers
|
Dear user,
You can refer to this LINK. https://forum.huawei.com/enterprise/en/The-whole-network-NTP-function-synchronization-problem/thread/540523-887 After the camera NTP time synchronization function is configured on a server, cameras will automatically time-synchronize with the server. Therefore, do not set the IP addresses of other clock sources on the camera web pages. Otherwise, the cameras will time-synchronize with the latter configured clock sources. Steps are as follows: 1. Log in to the OMU portal as the admin user. 2. Choose Maintenance > Unified Configuration. 3. Select the server to which the cameras need to connect, set Module name to SCU and Parameter type to System property, and click Search. 4. In the search results, click Edit in the row where Parameter Name is NTPIPC and set the Value as 1. 5. Click Save to enable the camera NTP time synchronization function. After the camera NTP time synchronization function has been enabled, the cameras, after being connected to the server, will automatically time-synchronize with the server.  |
|
All Answers
|
Dear user,
You can refer to this LINK. https://forum.huawei.com/enterprise/en/The-whole-network-NTP-function-synchronization-problem/thread/540523-887 After the camera NTP time synchronization function is configured on a server, cameras will automatically time-synchronize with the server. Therefore, do not set the IP addresses of other clock sources on the camera web pages. Otherwise, the cameras will time-synchronize with the latter configured clock sources. Steps are as follows: 1. Log in to the OMU portal as the admin user. 2. Choose Maintenance > Unified Configuration. 3. Select the server to which the cameras need to connect, set Module name to SCU and Parameter type to System property, and click Search. 4. In the search results, click Edit in the row where Parameter Name is NTPIPC and set the Value as 1. 5. Click Save to enable the camera NTP time synchronization function. After the camera NTP time synchronization function has been enabled, the cameras, after being connected to the server, will automatically time-synchronize with the server. |
|
Comment
Notice: To protect the legitimate rights and interests of you, the community, and third parties, do not release content that may bring legal risks to all parties, including but are not limited to the following:
- Politically sensitive content
- Content concerning pornography, gambling, and drug abuse
- Content that may disclose or infringe upon others ' commercial secrets, intellectual properties, including trade marks, copyrights, and patents, and personal privacy
