How to configure Tripwire Detection on VCN
Tripwire detection is used to detect whether an object steps over the tripwire along the specified direction in an observation area. If an object steps over the tripwire in the observation area, an alarm is generated. Surveillance personnel can view the video image and dispatch personnel to the site to handle the situation.
Prerequisites
•A camera supports intelligent analysis.
•Intelligent analysis has been enabled and common parameters have been set.
Procedure
1.Log in to the C/S client as the admin and double-click Devices.
2.Click the Local Domain tab.
3.Double-click the camera that needs to do intelligent analysis, and then click Intelligent Analysis.
4.Click the Tripwire Detection tab and configure tripwire detection, as shown below.
a.Set Alarm check interval (s) and Object identification mode. Table 1 describes the parameters.
b.Click Add Tripwire and set a tripwire.
c.Set the detection plan and select Enable plan.
5.Click Apply.
6.Click OK.
