How to configure prevent uplink flapping on MA5800 X7

Hello, friend!

You can run the port link-flapping(ethernet) command to enable or disable the smooth reporting of Ethernet port connection changes.

After this command is executed successfully, the smooth reporting interval is configured when the smooth reporting function of port connection changes is enabled.

1. Run the config command to enter global config mode, and then run the interface eth command to enter ETH mode.

2. Run the config command to enter global config mode, and then run the interface mpu command to enter MPU mode.

3. The port type auto-sensing and port link-flapping commands cannot be used simultaneously because the real-time dependency of port status update conflicts.

Thanks！