Hello everyone today I will share you guys how to confiure HWECC
Plan the DCC resource properly according to the configuration principle of the HWECC and discovered the HWECC by following required technique to form certain the effective oversight of the U2000 on the NEs.
Changing the ID of associate NE
You can use the U2000 to manage the initial planning and alter the ID of associate NE.
Prerequisites
。Log in to NE
。You ought associate NM user with NE operator authority or higher
Procedure
1 Select associate NE inside NE somebody want configuration> NE Attribute from the Function Tree
2 Click Modify NE ID. The Modify NE ID panel is displayed
3 Enter New ID and New Extended ID. Click OK
4 Then click OK inside the displayed panel
Follow-up Procedure
After you modify the ID of the NE, a heat reset is performed on the SCC board. throughout this case, you would like to log in to the NE over again once a particular quantity
Setting communication parameters of associate NE the communication parameters of associate NE embrace the scientific discipline address of the NE, address. you will use the U2000 to line the communication parameters.
Prerequisites
。Log in to NE
。You should be associate NM user with NE operator authority or higher
Procedure
1 choose associate NE from the item Tree within the NE someone. Opt for communication > Communication Parameters from the operate Tree
2 Set the communication parameters of the NE according to the network designing
3 Click Apply
Configuring DCCs
To meet the NM requirements of an advanced network, it is necessary to line the channel kind, enable/disable standing and protocol kind of DCC in line with the network designing
Prerequisites
。The user should log in to the NE
。You should be associate NM user with NE operator authority or higher
Context
NE used D1-D3 as DCC by default & accept the DCC communication
Procedure
1 Choose the NE from the item Tree within the NE someone. opt for Communication > DCC Management from the Function Tree
2 Click the DCC Rate Configuration tab. Then, click New. The system displays the panel. Set the port, channel kind, protocol kind and LAPD Role fields
3.Click OK and so click OK within the operation result panel
4 Optional: Click question to question DCCs
5 Optional: choose the required DCC, and modify the parameters in line with Table one. Then click Apply to complete the modification
