How to configure a Martini VPWS?
Created: Jun 12, 2020 19:52:24Latest reply: Jun 16, 2020 18:24:23
2384
4
0
0
0
Rewarded HiCoins：
2
(problem resolved)
Hi,
I've tried to configure a Martini VPWS (L2VC) in eNSP, but it didn't work in my lab.
I followed instructions on Hedex, but I wasn't able to bind a Vlanif to a L2VC;
Then I've tried communication through subinterfaces, even that it didn't work.
My target is to allow comunication from CE1 x CE2 via VLAN 20 (10.20.20.0/30) and allow communication from CE1 x CE3 via VLAN 30 (10.30.30.0/30).
The lab is in attachments.
- x
- convention：
- Emotion(0)
Featured Answers
All Answers
|
Hi ptomasi, The model 'router' doesn't support VPWS, please use the AR series or the NE router instead of the 'router'.
|
|
|
Thank you all for the information!
"run the mpls l2vpn default martini command" Great! I didn't know this difference between PWE3 VPWS and Martini VPWS. "The model 'router' doesn't support VPWS" Thanks, I've tought I was misconfiguring the VPWS commands. I'll try the scenario with AR series. 
|
|
Comment
Notice: To protect the legitimate rights and interests of you, the community, and third parties, do not release content that may bring legal risks to all parties, including but are not limited to the following:
- Politically sensitive content
- Content concerning pornography, gambling, and drug abuse
- Content that may disclose or infringe upon others ' commercial secrets, intellectual properties, including trade marks, copyrights, and patents, and personal privacy
