Abstract
This section describes how to configure a 10G GPON service board like CGHF, CSHF, XGHD, CGID…and configure the 10G GPON Port Attributes.
Configuring a 10G GPON Service Board
Adding a Board
You can add a 10G GPON service board using either of the following methods:
Manually inserting a board: When 10G GPON boards have been configured in the subrack, manually insert a required board.
Adding a board offline: When a 10G GPON service board needs to be pre-configured, add a 10G GPON service board offline.
NOTE:
In global config mode, run the board add frameid/slotidboard-type command to add a 10G GPON service board.
After a board is successfully added offline, the board status is Failed. However, you can still configure or query data on the board.
After a user manually inserts a board (the board type must be the same as that of the board added offline), the board status changes to Normal. Data configured for the board takes effect immediately after the configuration.
Configuring the Working Mode of a Board
The working mode of a service board (some specific service boards) can be set according to the actual application scenario.
Commands related to the working mode of a service board are as follows:
Run the gpon board workmode command to configure the working mode of a service board.
Run the display gpon board workmode command to query the working mode of a service board.
Configuring the 10G GPON Port Attributes
Automatic Discovery of an ONU
Adding an ONU offline: Before installing an ONU, manually add an ONU to the OLT and configure the ONU. After the ONU goes online, the OLU authenticates the ONU and issues configurations to the ONU.
Adding an ONU online: After an ONU is installed, the OLT discovers the online ONU and adds and configures it.
The automatic discovery of an ONU connecting to 10G GPON ports is disabled by default.
In 10G GPON interface mode, run the port ont-auto-find command to enable the automatic discovery of an ONT.
In 10G GPON interface mode, run the display ont autofind command to query the automatic discovery of an ONT.
Laser
Run a command to enable or disable a laser for a 10G GPON port.
The laser for a 10G GPON port is enabled by default.
In 10G GPON interface mode, run the shutdown command to disable a laser.
In 10G GPON interface mode, run the undo shutdown command to enable a laser.
NOTE:
After a laser is disabled, all services carried on the port with the laser are interrupted. Exercise caution when disabling a laser.
https://support.huawei.com/
