How to clear the iStack configuration from an S57000?

Busy_with_lazy_mind · Created Nov 24, 2014 09:44:18

There are two ways to splitting stack accord to different stack mode(service port mode, stack card mode).

1. Using service port

Run the system-view command to enter the system view.

Run the interface stack-port member-id/port-id command to enter the logical stack port view.

Run the shutdown interface { interface-type interface-number1 [ to interface-type interface-number2 ] } &<1-10> command to disable physical member ports.

Run the undo port interface { interface-type interface-number1 [ to interface-type interface-number2 ] } &<1-10> enable command to restore physical member ports to service ports.

Run the quit command to exit from a logical stack port.

Run the stack slot slot-id renumber 0 command to restore the stack ID of a member switch to the default value 0.

Power off all the member switches.

2. Using stack card.

Run the system-view command to enter the system view.

Run the stack slot slot-id renumber 0 command to restore the stack ID of a member switch to the default value 0.

Power off all the member switches.

Remove the stack card.

simonosullivan · Created Nov 27, 2014 02:07:58

Thanks for that. Have performed those commands.

The stack led on the front of both of the switches still flashes on and off constantly. If the stack was disabled I would have thought this light should be off?

Can you confirm that the stack config is fully cleared?

If I go "display stack current-configuration" and "display stack" this is the result:

---------------current-configuration on slot 0 Begin---------------
stack enable
stack slot 0 renumber 0
stack slot 0 priority 100
stack reserved-vlan 4093
stack timer mac-address switch-delay 10

interface stack-port 0/1

interface stack-port 0/2
---------------current-configuration on slot 0 End-----------------

<HUAWEI>display stack
Stack topology type: Link
Stack system MAC: 1051-7248-c114
MAC switch delay time: 10 min
Stack reserved vlan: 4093
Slot of the active management port: --
Slot Role Mac address Priority Device type
-------------------------------------------------------------
0 Master 1051-7248-c114 100 S5700-28X-LI-AC

Thanks very much for your help,

Simon

Danielarab · Created May 18, 2020 23:08:36

think is great

Danielarab · Created May 18, 2020 23:08:44

thank you for sharing

minervaE · Created May 31, 2020 22:45:26

Thanks

minervaE · Created May 31, 2020 22:48:38

Very useful, thanks

alejandrolla · Created Jul 8, 2020 23:30:46

Is good to know that

How to clear the iStack configuration from an S57000?

Third Party’s Trade Secret

My Followers

Enterprise

Consumer

Corporate

Carriers

How to clear the iStack configuration from an S57000?

Third Party’s Trade Secret

My Followers