How to check ONT hardware version on the OLT side and allow/block using service flows.

Hello, friend!

Can you provide the software version of the MA5608T?

According to your problem description, I still do not understand your question. Do you want to control the running and interruption of service flows by setting the hardware version?

Thanks!

Hello, friend!

I've read your question description and comments, but I'm still not sure what you're asking.

I mean for example :

I set 159D.A version to be able to use service flows after GPON S/N or password or loid auth (O5 state).

Someone is connecting a ONT with a different hardware version (635.A), O5 state of course but can't access to the service flows behind (mean VLAN for the example). 

As for the preceding description, I understand you want to change the ONT hardware version on the OLT to control service flows allow/block.

But I need to be clear, the OLT does not support the query of the ONT hardware version, and The ONT hardware version cannot be changed on the OLT.

After confirmation:

The ONT hardware version cannot be changed to control service flows allow/block.

Thanks!

Hello, friend!

I am sorry for the late feedback, as I confirmed several times to get the following information:

Configure the ONT trustlist function. After the function is enabled, only the ONTs in the trustlist can go online. Other ONTs cannot go online. This function is disabled by default and takes effect in real time. 

Configures, deletes, and queries the ONT type information in the trustlist, including the vendor flag, device type, and software version. The information takes effect in real time.
The ONT offline reason is added, indicating that the ONT is not in the trustlist and cannot go online.

Query and set commands. MIBs are not supported. 

display xpon ont-trustlist gpon 

xpon ont-trustlist gpon vendor 

xpon ont-trustlist gpon {disable | enable}

Thanks!

Hello @Chenxintao,

The choices that i get when i'm doing a "display xpon ?" command :

Thanks.

Hello, friend!

Due to the differences between device versions, the commands of the device are different.

The display xpon ont-whitelist gpon command has the same function as the display xpon ont-trustlist gpon command for querying GPON ONT trustlist parameters.

display xpon ont-whitelist gpon [ vendor { vendor-id | hex vendor-id } [ equipment { equipment-id | hex equipment-id } [ software-version software-version ] ] ]

The xpon ont-whitelist gpon vendor command is used to set a GPON ONT trustlist. The ONT trustlist consists of the ONT vendor ID, ONT device ID, or ONT version information. Only the ONTs that meet the ONT trustlist configuration can be authenticated. To control the type of ONTs that can go online, run this command.

The undo xpon ont-whitelist gpon command is used to delete the GPON ONT trustlist configured based on the ONT vendor ID, ONT device ID, and ONT version.

The xpon ont-whitelist gpon command is used to enable or disable the ONT trustlist to go online. If you need to configure an ONT trustlist to control the ONT going online, turn on the switch. If the ONT trustlist function does not need to be configured on the, set this parameter to OFF.