How to change a Fit AP to a Fat AP?

Hello,

Follow the steps below to connect to the AP and switch it to FAT mode.

1. Set the IP address of the PC to 169.254.1.100 and the mask to 255.255.0.0 so that the PC and the AP are on the same network

segment.

2. Open PuTTY on the PC, enter the IP address and port number of the AP, select the SSH mode and click Open. If a key pair information request is displayed, click Yes.

3. When the following information is displayed, the AP connects successfully. Enter the username and password to log in

to the
AP. log
in as: admin Additional authentication required admin@169.254.1.1password: admin@huawei.com // For information security, the characters you entered are invisible.

Info: Current mode: Tuning (managed by the

CA). The current mode is Fit.

Information: It is recommended to change the password to ensure security.


<Huawei>4. Check the information

of AP. <Huawei>show the
version Versatile Routing Platform Software
Huawei Software VRP (R), Version 5.170 (AP4050DN FIT V200R007C20SPCa00)
// Model, working mode and version ...

Initiate the change.

5. Change ap mode to Fat. The AP will restart and the restart takes about 2 minutes. <Huawei> System View
[Huawei] ap-mode-switch fat
Warning: The system will restart and start in V200R007C20SPCa00 fat mode.



Continue? (and/n) [n]:
and Information: the system is restarting, please wait .................

After restarting, log in again and check the

version