How to add a slave subrack using CLI on OSN 1800 (F3SCC)

Hi there!

This time, I will share with you about How to add a slave subrack using CLI on OSN 1800 (F3SCC).

In order to add a slave subrack using SSH/CLI, you must run following comands.

Note:

Only for F3SCC CLI commands are supported.

Procedure:

1. Run the 'system-view' command to access the System View.

2. In System View, run 'device chassis' to add a logical slave subrack.

3. In System View, run the 'shelfid' command to associate the physical subrack.

4. In System View, run the 'active shelfid' command to activate the physical subracks.

Notice:

Changing a subrack ID may cause communication interruption!

Replacing a subrack can cause service interruption!

That's all, I welcome everyone to leave a message and exchange in the comment area!

Thank you！