How configure max transmission power for RTN510?

This post was last edited by yjhd at 2019-02-18 02:34. RTN510 has AP and RT, The max power of AP is 26W/-48V, the max power of RT is 10.5W/-48V. we can't configure the max power manually.

Configure the country, antenna gain, and transmit power according to the planning document. Ensure that the configured antenna gain plus the configured transmit power is less than or equal to the maximum EIRP configured for the country.

Generally, a frequency range is provided in the planning document. Select all channels within the frequency range.

Downlink/Uplink Ratio: If this parameter is not set to flexible, enable GPS time synchronization and set this parameter according to site requirements

 

The Tx power for RTN is depending upon the Radio working modes configured in the RTN. There are 3 modulation scheme in RTN510. 10MHz, 20MHz and 40MHz. For instance, if we configured working modulation to MCS7/10MHz, the Tx power range will 0 to 19. Meaning that 19 is the maximum transmit power that can be configured.