Procedure

1. Choose Settings > Alarm > Alarm.

   
   

   The Alarm page is displayed, as shown in Figure 1.

   NOTE:

   After the IPC6126–WDL-LPR alarm output interface is connected to the auxiliary light source, other alarm output devices cannot be connected.

   Figure 1 Alarm page
   

   
   

   
   

   

2. Set parameters. For detailed parameter description, see Table 11-3.

   
   

   Table 1 Parameter description

   Parameter		Description
   Alarm input	Device ID	ID of the alarm input device.
   	Enable	Whether to enable the alarm input function.
   	Name	User-defined device name.
   	Type	Select either Normally open or Normally close based on the device status.
   	Alarm check interval	Time interval at which the system checks for new alarms.
   Alarm output	Device ID	ID of the alarm output device.
   		Manual control of the output device status. NOTE: This function cannot be used with the alarm linkage function. If the function is used with the alarm linkage function, the alarm linkage actions will be affected.
   	Name	User-defined device name.
   	Duration	Duration that an output alarm lasts. NOTE: If Duration is set to 0, the alarm persists permanently.

   
   

   
   

3. Click Save.