Hi my dear,

To query the current traffic of GPON port 0/3/0, do as follows:

huawei(config-if-gpon-0/3)#display port traffic 0                                { <cr>||<K> }:                                                                  

                                                                                

  Command:                                                                      

          display port traffic 0                                                

 ----------------------------------------------------------------

  Traffic Information

 ----------------------------------------------------------------

 Up traffic (kbps)          :  0

 Down traffic (kbps)        :  0

 ----------------------------------------------------------------

 Traffic of upstream broadcast frames(packets/s)    :  0

 Traffic of upstream multicast frames(packets/s)    :  0

 Traffic of upstream unicast frames(packets/s)      :  0

 Traffic of downstream broadcast frames(packets/s)  :  0

 Traffic of downstream multicast frames(packets/s)  :  0

 Traffic of downstream unicast frames(packets/s)    :  0

 ----------------------------------------------------------------

 UP bandwidth occupied percentage                   :  0%                       

 Down bandwidth occupied percentage                 :  0%                       

 ----------------------------------------------------------------

You can check the optical power of the OLT in the following three situations:

1. You can use an optical power meter to measure the upstream and downstream optical power.

2. You can run the display port state(gpon) command to query the status of the GPON port, including the hardware information and optical power of the optical module.

You can run the display port state(epon) command to query the status of an EPON port, including the hardware information and optical power of the optical module.

3. On the NMS, click Optical Power Management to view the optical power of the port.

Thank you

Hello, friend!

You can run the display ont traffic command to query the real-time traffic of an ONT.

huawei(config-if-gpon-0/3)#display ont traffic

{ portid<U><0,15> }:0 

{ all<K>|ontid<U><0,127> }:all

{ <cr>|<K> }:


  Command:                                                                         

          display ont traffic 0 all

  Command is being executed. Please wait

 ----------------------------------------------------------------

 ONT ID            Up traffic (kbps)          Down traffic (kbps)

 ----------------------------------------------------------------

      0                            5                            0

      1                            5                            0

      2                            5                            0

      3                            5                            0

      4                            5                            0

      5                            5                            0

 ----------------------------------------------------------------

Thanks!