helping in deploying configuration from AC6005 to 9 APS AP5130DN

waiting for help

What you said is that the AP isn`t online in the controller, and the SSID hw_manage_xxxx is their own SSID for every AP to config.

The first step that you must let the link AP----SW-----controller use a managed vlan, and let the AP go online.

you can use the document as follow:

http://support.huawei.com/hedex/hdx.do?docid=EDOC1000088060&lang=en

the case:
Example for Configuring Layer 2 Tunnel Forwarding in Bypass Mode

is it necessary to create a vlan for management?

right now ac switch and ap are in vlan1 and in the same subnet of the router, and for us (small office) it's ok like this. Thanks for the link that is very useful, could you please explain in a lower level how very basic installation works? i mean controller deploying configuration to aps.

Thank you very much

What i mean is, in the document seems that the AC can deploy the config to any ap that it knows the mac adress and serial number, i think i can set in the ap the ip or mac adress of the controller from where grabbing configuration. Am i wrong?

I followed the document step by step, even resetting to factory defaults an access point to check if it can go online on the AC but it didn't work, our network schema is the following:

ROUTER 192.168.3.1 -> POE MANAGED SWITCH -> AC6005 192.168.3.2 -> 9 x AP5130DN (192.168.3.3 - 11)

All APS are configured and reacheable from web manager but as stand alone aps, not getting config from the controller.

APS are not connected directly to the AC but are connected to the POE switch (HPE 3600 24 PoE+ V2), we using only VLAN1, all ports untagged member VLAN1 and only one Virtual Interface in the VLAN1 192.168.3.2

Access Points don't want to go online with the AC, i even tried to add it manually with mac adress and serial number, username and password for managing it's the same.... But all the APS remain idle, i can reach the APS and the controller from my laptop, but seems AC and APS doesen't want to communicate, please help me, because my colleagues are looking forward to trash all the Huawei infrastructure and buy ubiquiti, but i'm sure huawei is much much better and i want to fix the situation.

Are the APs in FAT AP Mode?

How can i check it?

Login to the AP directly (via Console/Serial Cable) and use the command "display version".
If something like FatAP4X30XN_V200R006C10SPCa00 shows up, you need to switch the AP Mode to Fit AP.

this is the helping we are seeking to it in the forum