Hello, friend!
According to the error message displayed on the configuration page, the configuration parameter is incorrect.
For details, see the following parameters:
Enable WLAN
Indicates whether to enable the wireless network- The following parameters can be set only when the wireless network is enabled
SSID Name
Indicates the name of the Wireless network It is used to differentiate different Wireless networks. It consists of a maximum of 32 characters,
Without Tab character, A default SSID1, named WirelessNet is created after the creation of an ONT The system can configure up to four
SSIDs at a time and cannot assign IP addresses to Wi-Fi terminals by SSID
Enable SSID
Specifies whether to enable the connection
Number of Associated Devices
Specifies the number of STAs. ic ranges from 1 to 32
Broadcast SSID
Indicates whether to enable or hide broadcast.
1. lf the option box is selected, it indicates that the SSID broadcast function is enabled. The ONT periodically broadcasts the SSID, that is,
the name of the Wireless network In this way, any STA can search for the wireless network.
2. if the option box is not selected, it indicates that the SSID broadcast function is disabled. The SSID is hidden, and the STA can not search
for the wireless network. The SSID can be obtained only through a request
Specifies whether to enable Wi-Fi multimedia.
Enable WMM
Specifies whether to enable Wi-Fi multimedia.
Authentication Mode
Indicates the authentication mode for the STA to request access to the wireless network. The mode can be Open, Shared, WPA
PreSharedKey WPA2 PreSharedKey WPA/WPA2 PreSharedKey WPA Enterprise, WPA2 Enterprise, or PA/WPA2 Enterprise. It is set to Open by default that is, the STA can access the network without authentication
Encryption Mode
Indicates the encryption mode for the STA to request access to the wireless network The encryption mode and encryption parameters vary
With the authentication mode.
1. If the authentication mode is set to Open, the encryption mode can be set to None or WEP.
2. lf the authentication mode is set to Shared, the encryption WEP
3. if the authentication mode is set to
WPA PreSharedKey WPA2 PreSharedKey, WPA/WPA2 PreSharedKey, WPA Enterprise, WPA2 Enterprise or WPA/WPA2 Enterprise, the
encryption mode can be set to AES, TKIP, or TKIP&AES.
NOTICE:
WEP is an insecure encryption algorithm Therefore, Using AES, TKIP TKIP&AES or an algorithm with a higher security level is recommended.
Enable WPS
Specifies whether to enable the WPS function_
WPS Mode
Indicates the WPS mode which supports automatic configuration of the network name, that is, the service set identifier (SSID), and the
WPA security key_ With WPS, users do not need to keep lengthy passwords to achieve secure connection_ Specifically the secure connection
can be achieved by three modes, which are PBC, PIN, and AP PIN.
1. In PBC mode, the button is pressed to achieve a secure WPS connection.
2. In PIN mode, the STA PIN is entered on an ONT to achieve a secure WPS connection.
3. ln AP PIN mode, the PIN generated by an ONT is entered to achieve a Secure WPS connection
Thanks!
