Hello everyone!!!
I share with you this small guide to perform a Health Check on a Huawei Storage using the SmartKit tool.
1. Open the SmartKit tool.
2. In the STORAGE part, select the Health Check option located in the Routine Maintenance box.
NOTE: It will probably ask you to do an UPGRADE which will take about 20 minutes to complete, if you need to have a good Internet connection. If the UPGRADE cannot be performed, the procedure can be continued without problems.
3. Start the Health Check. When selecting the "DEVICE SELECTION" option, it will ask you to add a device. When adding the device, it will ask for your credentials (username and password) if everything is correct, it will appear as in the following figure.
NOTE: Add the path to save the inspection result where it says "RESULT FOLDER".
4. Subsequently, the Health Check inspection process will start. To do this, you can select which characteristics you want it to analyze of the equipment, in this case all the options were selected.
5. End of the Health Check process. Since the Health Check has finished, BEFORE FINISHING IT, you must select the Open the result folder box, which will take you to the path where it was saved.
NOTE: It is necessary to make sure that everything is well connected before performing the Health Check, especially the electrical cables, since that may be a cause that prevents the Health Check from being successful. If for some reason, the Health Check IS NOT SUCCESSFUL, it is necessary to review the report and there will appear tips to correct the errors and to pass the Health Check in the following attempts.
Regards!!!
