Got it

HCNP-Storage-CUSN Examination

Latest reply: Dec 30, 2016 13:13:52 1861 1 0 0 0
1.(single-choice)What is the most common protocol used in a SAN environment?
  1. A.SCSI
  2. B.Fibre Channel
  3. C.FCoE
  4. D.All answers apply
  5.  

2.(Multiple-choices)Which of the following are disadvantages of a FC SAN?

  1. A.Costs
  2. B.Scalability
  3. C.Not yet fully heterogeneous
  4. D.Reliability
  5.  

 3.(single-choice)Which of the following statements is correct.
Statement 1: A 6800 V3 can hold less different I/O modules than a 5800 V3?
Statement 2: For all models the rule applies that identical bay numbers for each controller node must contain the same I/O module?

  1. A.Statement 1 and 2 are both true.
  2. B.Statement 1 is true. Statement 2 is false.
  3. C.Statement 1 is false.Statement 2 is true.
  4. D.Statement 1 and 2 are both false.
  5.  

 4.(single-choice)Data blocks that have been modified since the activation of a Virtual Snapshot Task reside on?

  1. A.Source LUN
  2. B.Recource LUN
  3. C.Snapshot
  4. D.Virtual snapshot
  5.  

5.(Multiple-choices)A consistency groups simultaneously.

  1. A.Synchronizes all members.
  2. B.Splits all members.
  3. C.Disconnects all members.
  4. D.Copies all members.
  5. E.Switches over from primary to secondary.
  6.  

 6.(True or False)HyperMirror is a LUN based feature whereas SmartVirtualization is based on virtualizing a complete third party array.

 7.(Single-choice)Which of the following statements about SmartQoS is true:
       A) Lower-priority I/O can be rejected in favor of higher-priority I/O?
       B) SmartQoS uses a queuing system for I/O requests?

  1. A.Statement A is true and Statement B is false.
  2. B.Statement A is false and Statement B is true.
  3. C.Both statements are true.
  4. D.Both statements are false.
  5.  

 8.(True or False)Failure of the Intra-city DR site would impact connectivity of the Remote site in a cascaded.

 9.(Multiple-choices)Which factors should be considered when planning basic services of a storage system?
          A.Storage tier
          B.LUN clone
          C.RAID level
          D.Hot spare policy

10.(Multiple-choices)What are valid criteria in determining the required capacity for a solution?

  1. A.Retention time for snapshots
  2. B.Number of snapshots
  3. C.Disk-to-Disk-to-Tape backup
  4. D.Number of IOPS needed
  5.  

 11.(Single-choice)Which tool cannot be run in a Linux based operating system?

  1. A.Nagios
  2. B.Zabbix
  3. C.Cacti
  4. D.SQLIO
  5.  

 12.(True or False)The number of disks in a storage pool can be changed in a later stage.

 13.(Multiple-choices)When can the use of SmartThin LUNs be considered?

  1. A.For LUNs with unpredictable amounts of writes to them.
  2. B.When overprovisioning can easily be solved by adding disks quickly.
  3. C.If the amount of free space greatly exceeds the required LUN capacity.
  4. D.If the operating system supports re-thinning.
  5.  

 14.(Single-choice)What is the default port for DeviceManager?

  1. A.8008
  2. B.8080
  3. C.8088
  4. D.8888
  5.  

 15.(Multiple-choices)A SmartMigration task fails. This could be caused by;

  1. A.The source LUN is smaller than the target LUN.
  2. B.The target LUN is not on the same controller.
  3. C.The target LUN is in use by another service.
  4. D.The target LUN is not mapped to a host.
  5.  

 16.(Single-choice)The real-time inspection tool in the OceanStor Toolkit can tell us.

  1. A.The status of a link.
  2. B.The bit errors on a link.
  3. C.The status of the fans.
  4. D.The power consumption of the device.
  5. E.All of the above.
  6.  

 17.(Single-choice)When restarting an OceanStor V3 engine, we should:

  1. A.Make sure the power is off.
  2. B.Make sure no service is running on any of the controllers.
  3. C.Make sure a second device can take over all services.
  4. D.Make sure all disks are powered off.
  5.  

 18.(Single-choice)Assuming a setup with 1 host (A) , 1 controller (B), 1 switch (C) and 1 disk enclosure (D). The correct order of powering on in a new installation is:

  1. A.A-B-C-D
  2. B.D-C-B-A
  3. C.A-C-B-D
  4. D.D-B-C-A
  5.  

 19.(Multiple-choices)The configuration of ip addressing is done under.

  1. A.Settings
  2. B.Provisioning
  3. C.Configuration
  4. D.System
  5.  

 20. (True or False)When creating disk domains select the option “All available disks” and then manually select disks.

Answer:
/ 1 B / 2 AC / 3 B / 4 C / 5 ABCE / 6 F / 7 C / 8 T / 9 ACD / 10 ABC / 11 D / 12 F / 13 BCD / 14 C / 15 BC / 16 E / 17 B / 18 D / 19 BD / 20 F
View more
  • x
  • convention:

Comment

You need to log in to comment to the post Login | Register
Comment

Notice: To protect the legitimate rights and interests of you, the community, and third parties, do not release content that may bring legal risks to all parties, including but are not limited to the following:
  • Politically sensitive content
  • Content concerning pornography, gambling, and drug abuse
  • Content that may disclose or infringe upon others ' commercial secrets, intellectual properties, including trade marks, copyrights, and patents, and personal privacy
Do not share your account and password with others. All operations performed using your account will be regarded as your own actions and all consequences arising therefrom will be borne by you. For details, see " User Agreement."

My Followers

Login and enjoy all the member benefits

Login

Block
Are you sure to block this user?
Users on your blacklist cannot comment on your post,cannot mention you, cannot send you private messages.
Reminder
Please bind your phone number to obtain invitation bonus.