Hardware Check After Camera Installation

little_fish · Created Nov 26, 2020 06:31:52

Dear Phany,

Have a good day.

After the device is installed and services are configured, check whether the device is installed correctly and whether the license plate capture and recognition effect are as expected by referring to the following checklist.

Table Check items for installation

No.	Item
1	All screws are fully tightened.
2	The camera is securely installed on the support or wall.
3	Necessary protection measures have been taken for the camera.
4	The ambient temperature meets the device specifications.
5	Insulation and waterproofing measures have been taken to protect cables installed in humid or unprotected environment, and the drip loops are in correct positions.
6	The camera is grounded, and if it is powered by PoE, the PoE switch is grounded too.
7	The protective film and fixing rubber strip have been removed from the lens and camera body respectively.
8	The camera can be powered on and run properly.

Thank you.

little_fish · Created Nov 26, 2020 06:27:53

Dear, check whether the device is installed correctly is a very important step. I will give you a checklist.

little_fish · Created Nov 26, 2020 06:31:52

Dear Phany,

Have a good day.

After the device is installed and services are configured, check whether the device is installed correctly and whether the license plate capture and recognition effect are as expected by referring to the following checklist.

Table Check items for installation

No.	Item
1	All screws are fully tightened.
2	The camera is securely installed on the support or wall.
3	Necessary protection measures have been taken for the camera.
4	The ambient temperature meets the device specifications.
5	Insulation and waterproofing measures have been taken to protect cables installed in humid or unprotected environment, and the drip loops are in correct positions.
6	The camera is grounded, and if it is powered by PoE, the PoE switch is grounded too.
7	The protective film and fixing rubber strip have been removed from the lens and camera body respectively.
8	The camera can be powered on and run properly.

Thank you.

Phany · Created Nov 27, 2020 13:13:10

Posted by little_fish at 2020-11-26 06:31 Dear Phany,Have a good day.After the device is installed and services are configured, check whether ...

Check them all!!!

Unicef · Created Nov 14, 2021 14:44:13

Good answer

Hardware Check After Camera Installation

Best answer

Third Party’s Trade Secret

My Followers

Enterprise

Consumer

Corporate

Carriers

Hardware Check After Camera Installation

Best answer

Third Party’s Trade Secret

My Followers