Hard disk unit SM-HDD-SAS300G-A, 3 U device
1.Remove the filler panel from a hard disk slot.
2.Hold the handlers of the tray and push the tray along the guide rails inside the hard disk slot till the tray panel aligns with the panel of the device.
3.Press the tray handler inwardly to its original position. For a device with a single hard disk, after the device is powered on, run the display disk information command to check whether Filesystem Status is Mounted. For a device with dual hard disks, after the device is powered on, run the reset raid primary-disk disk-id command in the system view to create RAID1 with the specified disk (disk-id) as the primary disk. After 4 to 5 hours, run the display disk information command to check whether Filesystem Status is Mounted and whether DiskRaidMode is ACTIVE.
