FAQ-common commands about hard disk-reset raid
Page 25reset raid
<sysname> system-view
[sysname] reset raid
Warning: Are you sure you want to delete RAID? [Y/N]y
//When the device has only one hard disk or does not have hard disks, data backup is not required, and you can run the reset raid command to delete RAID information.
//In the hard disk replacement scenario, you are advised to delete RAID information and create a RAID again to prevent the display of incorrect information. For detailed operations, see page 14.
-------------------------------------------------------------------------------------------------------
<sysname> system-view
[sysname] reset raid primary-disk 0 Warning: Are you sure to rebuild RAID, using disk 0 as the primary disk? It will take one minute.[Y/N] y
//When two hard disks are used for the first time or you need to back up the hard disk data to a new disk, run the reset raid primary-disk disk-id command to create RAID1.
//When two hard disks on the device have different data, you can run the reset raid primary-disk disk-id command to reset RAID1 and synchronize data from the primary hard disk to another hard disk.
