Failed to Set Up an SVF System When a CE6850EI Functions as the Parent Switch an

Nana00 · Created May 17, 2016 06:32:00

Handling Process

Run the stack member { member-id | all } domain domain-id command in the stack management view on the parent switch to configure a stack domain ID and then run the save command in the user view to save the configuration. The configured stack domain ID takes effect after the configuration is saved. Subsequently, leaf switches can join the SVF system.

Root Cause

Run the display stack configuration command to check the SVF configuration of the parent switch. The command output shows that no stack domain ID is configured for the parent switch.

As a result, the SVF system cannot be set up.

<HUAWEI> display stack configuration
Oper          : Operation
Conf          : Configuration
*             : Offline configuration
Isolated Port : The port is in stack mode, but does not belong to any Stack-Port
                or Fabric-Port

System Forwarding Model:
-------------------------------
Oper               Conf
-------------------------------
distributed        distributed
-------------------------------

Spine Attribute Configuration:
--------------------------------------------------
MemberID         Domain          Priority
Oper(Conf)       Oper(Conf)       Oper(Conf)
--------------------------------------------------
1(1)             --(--)           100(100)
--------------------------------------------------

Stack-Port Configuration:
--------------------------------------------------------------------------------
Stack-Port      Member Ports
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------

Fabric-Port Configuration:
---------------------------------------------------------------------------------
Fabric-Port     BindMember   Ports
---------------------------------------------------------------------------------
Fabric-Port1    101          10GE1/0/48
---------------------------------------------------------------------------------

Isolated Port Configuration:
10GE1/0/45          10GE1/0/46          10GE1/0/47

Nana00 · Created May 17, 2016 06:32:58

Suggestions

When a single switch is used as the parent switch, you must configure a stack domain ID for the switch. Otherwise, the SVF system cannot be set up.

AndreaBri · Created Apr 30, 2020 10:56:35

Useful document, thanks

AndreaBri · Created Apr 30, 2020 10:56:43

well done

Failed to Set Up an SVF System When a CE6850EI Functions as the Parent Switch an

Third Party’s Trade Secret

My Followers

Enterprise

Consumer

Corporate

Carriers

Failed to Set Up an SVF System When a CE6850EI Functions as the Parent Switch an

Third Party’s Trade Secret

My Followers