Factory reset SCC card on E6608T

Dear friend!

You can create NEs on the NMS. select Initialize and Manually Configure NE Data and click Next. The Confirm dialog box is displayed, indicating that manual configuration clears the data on the NE side.

If the NE exists on the NMS, please delete it and then create it in the preceding way. 

Note: Initializing a device will cause the loss of all device configuration data and interruption of all services carried by the device. Therefore, you are advised to perform this operation with caution and back up NE data before performing this operation.

Thank you！

Correct me if I am wrong:
Solution:
Step 1: Login into the DC tool
Step 2: After you will be logged in, the interface is similar as in the U2000:

WEBLCT:

Step 3: You can select the device and click right and initialize the device database.
Step 4: Cold reset the SCC

NOTE:
Please keep in mind, during this procedure all the service configuration will be deleted and the service will be down.

Thanks!

Yes, the method you provide will do as well.
You can also use the Navigator tool to run the following commands:
:cfg-init-all

Thanks!