This post is about facing an issue with the tunnel selector on eNSP 1.3.00.100.
The eNSP software version was in both cases 1.3.00.100.
I ran the following test with the old VRP5 router and with the new CX600 (VRP8) router.
I have set up a Seamless BGP LSP across two different IP Domains.
In the left domain (the topology is in the attached eNSP files, just unzip and double click the topology), I configured LDP LSP.
In the domain on the right hand side, I configured RSVP-TE LSP.
I configured the tunnel selector on R3 and R5 so that BGP LSP takes the RSVP TE LSP.
Results:
- when using the old VRP 5 router, CEA is able to ping CEB;
- when using the new CX600 VRP8 router, CEA cannot ping CEB any longer (note that PEB can ping CEA, but PEA is not able to ping CEB);
- configuration looks okay to me, e.g. I check 'display ip vpn-instance huawei tunnel-info' on PEs and CLI output shows that there VPN traffic will be iterated to the BGP LSP.
eNSP files can be found in the attached archive.