Experience using the Firewall (USG6000V) Web UI on eNSP

Hello, everyone!

This post will showcase my experience using the Firewall (USG6000V) Web UI on eNSP.

In addition, it will explain how I created the basic configuration and how I accessed the Firewall (USG6000V) Web UI on eNSP. Please see the below steps.

PROCEDURE

1. Connect the FW to the Cloud as shown below.

Note:

In this example, I used the Wireless Network Connection to the Cloud. This will also be used in the IP configuration in Step 4.

2. Configure the login interface.

a) Set the interface information.

[FW] interface GigabitEthernet 1/0/3

[FW-GigabitEthernet1/0/3] ip address 10.3.0.1 24

[FW-GigabitEthernet1/0/3] service-manage enable

[FW-GigabitEthernet1/0/3] service-manage https permit

[FW-GigabitEthernet1/0/3] quit

b) Add the interface to a security zone.

[FW] firewall zone trust

[FW-zone-trust] add interface GigabitEthernet1/0/3

[FW-zone-trust] quit

3. Create an administrator.

a) Configure a trusted host for the administrator.

[FW] acl 2001

[FW-acl-basic-2001] rule permit source 10.3.0.0 0.0.0.255

[FW-acl-basic-2001] rule 10 deny

[FW-acl-basic-2001] quit

b) Create an administrator role.

[FW] aaa

[FW-aaa] role service-admin

[FW-aaa-role-service-admin] description policy_object_network_readwrite_and_other_modules_none

[FW-aaa-role-service-admin] dashboard none

[FW-aaa-role-service-admin] monitor none

[FW-aaa-role-service-admin] system none

[FW-aaa-role-service-admin] network read-write

[FW-aaa-role-service-admin] object read-write

[FW-aaa-role-service-admin] policy read-write

[FW-aaa-role-service-admin] quit

c) Create an administrator and bind a role to the administrator.

[FW-aaa] manager-user webadmin

[FW-aaa-manager-user-webadmin] password

Enter Password:

Confirm Password:

[FW-aaa-manager-user-webadmin] service-type web

[FW-aaa-manager-user-webadmin] access-limit 10

[FW-aaa-manager-user-webadmin] acl-number 2001

[FW-aaa-manager-user-webadmin] quit

[FW-aaa] bind manager-user webadmin role service-admin

[FW-aaa] quit

4. Verify the login to the Web UI.

a) Set the IP address of your PC as 10.3.0.10/24.

Note: 

I used the Wireless Area Connection as stated in Step 1.

b) Open a browser and enter https://10.3.0.1:8443.

c) On the login UI, enter user name webadmin and password <password> and click Login to access the web UI.

This would be all on my experience using the Firewall (USG6000V) Web UI on eNSP. Thanks for reading this post!