Procedure
Run:
system-view
The system view is displayed.
Run:
stp enable
STP/RSTP is enabled on the switching device.
By default, STP/RSTP is enabled on a device. If you specify a VLANIF interface of a VLAN as the management network interface for an MSTP-enabled device, you can run the ethernet-loop-protection ignored-vlan command to specify this VLAN as an ignored VLAN. Then interfaces in the ignored VLAN will not enter the Blocking state and stay in the Forwarding state. Therefore, services will not be interrupted on these interfaces.
Stay connected! Choose the types of newsletters you want to receive!
Enabling STP/RSTP
Created: Aug 1, 2018 18:28:38
296
0
1
0
- x
- convention：
Comment
Notice: To protect the legitimate rights and interests of you, the community, and third parties, do not release content that may bring legal risks to all parties, including but are not limited to the following:
- Politically sensitive content
- Content concerning pornography, gambling, and drug abuse
- Content that may disclose or infringe upon others ' commercial secrets, intellectual properties, including trade marks, copyrights, and patents, and personal privacy
