This section describe all the electrical connection of Battery LUNA2000.
Installing an internal ground cable 2. Installing internal DC terminals
3. Connecting internal signal cable
When a communications terminal is connected to a single network cable, a waterproof rubber plug must be installed.
After inserting the terminal shell into the COM port, shake the terminal shell left and right and pull it back to ensure that it is securely installed, and tighten the nut (ensure that the rubber plug is tightly compressed). Otherwise, the waterproof performance is affected.
4. Connecting external ground cable
Ground a ground point of the power control module.
Apply silica gel or paint around the ground terminal after the ground cable is connected.
5. Installing the DC input power cables
Use dedicated insulated tools to connect cables. Ensure that battery cables are connected to correct polarities. If the battery cables are reversely connected, the battery may be damaged.
6. Installling signal cable with inverter
COM PORT DEFINITION:
6.1 Connection with inverter SUN2000 2-6KTL-L1
6.2 Connection with inverter SUN2000 3-10KTL-M1
7. Installing the cover
After electrical connections are complete, check that cables are correctly and securely connected, install the external protective cover, and secure it using screws.
