DSP IPPATH empty

Got it

Huawei Enterprise Support Community

Created: Jan 23, 2019 14:14:50Latest reply: Jan 25, 2019 06:08:37 678 1 0 0 0

When S1-U is configured in End Point configuration mode, the DSP IPPATH will result empty. You will have results for DSP IPPATH only in case of Link configuration mode.

To check the user plane on the End Point Configuration mode, use the command "DSP EPGROUP" in eNodeb and "DSP PDPCTXT" in eCore.

x
convention：
Emotion(0)

Like (0) Dislike (0) Favorite(0) Report

 Previous: Synchronization with 1PPS+TOD for eLTE TDD enodeb

Next: The CPE（EG860） fails to connect to the OMC.



(0) (0)

^2#

user_29203322 Created Jan 25, 2019 06:08:37

good share

x
convention：

Comment

Notice: To protect the legitimate rights and interests of you, the community, and third parties, do not release content that may bring legal risks to all parties, including but are not limited to the following:

Politically sensitive content
Content concerning pornography, gambling, and drug abuse
Content that may disclose or infringe upon others ' commercial secrets, intellectual properties, including trade marks, copyrights, and patents, and personal privacy

Do not share your account and password with others. All operations performed using your account will be regarded as your own actions and all consequences arising therefrom will be borne by you. For details, see " User Agreement."

My Followers

Are you sure to block this user?
Users on your blacklist cannot comment on your post,cannot mention you, cannot send you private messages.

Please bind your phone number to obtain invitation bonus.

Enterprise

Consumer

Corporate

Carriers

Third Party’s Trade Secret

My Followers