Hello, friend!
The MA5616 supports the emergency standalone function. After the emergency standalone function is configured on the MA5616, the MA5616 automatically processes the internal users of the same MG interface when the MA5616 is disconnected from the MGC. In this way, the internal users can communicate with each other without being controlled by the MGC.
Prerequisites
It indicates that the protocol type of the MG interface is H.248.
The media IP address already exists in the IP address pool.
Voice users are configured on the MG interface, and the users can communicate with each other.
If the device fails to communicate with the MG, run the system parameters 5 commands to set the forwarding mode of the media stream to the internal forwarding mode of the device.
The telephone number of the MG user must be configured and consistent with that on the MGC.
Context
When the MG interface works in the emergency standalone state, only the internal users of the MG interface can communicate with each other.
To ensure that the telephone number used by the user in the emergency standalone state is the same as the telephone number used in the normal state, the telephone number on the MG side is usually the same as the telephone number configured on the MGC side.
Procedure
1. Run mg-software parameter 11 command to configure the MG interface to support the emergency standalone function.
2. Run digitmap set inner command to configure the internal digitmap.
3. (Optional) Run standalone parameters command to configure the standalone parameters.
Thanks!
