Direct Connection Between an AP's Wired Interface and a Wired Terminal in the Centralized Architecture

Direct Connection Between an AP's Wired Interface and a Wired Terminal in the Centralized Architecture

As shown in Figure , the wired interface Eth0/0/1 on the AP is directly connected to a wired terminal. Perform the following configurations to achieve wired network interworking.

Figure Networking diagram for the direct connection between an AP's wired interface and a wired terminal in the centralized architecture 

• Configure the wired interface GE0/0/0 on the AP.
  1. Run system-view

     The system view is displayed.

  2. Run wlan

     The WLAN view is displayed.

  3. Run wired-port-profile name profile-name

     An AP wired port profile is created, and the AP wired port profile view is displayed.

     By default, the system provides the AP wired port profile default.

  4. Run mode root

     The working mode of the wired interface is set to root.

  5. (Optional) Run vlan tagged { vlan-id1 [ to vlan-id2 ] } &<1-10>

     The wired interface is added to one or more VLANs.

  6. Run quit

     Return to the WLAN view.

  7. Bind the AP wired port profile to an AP group or AP.

     
     

• Configure the wired interface Eth0/0/1 on the AP.
  1. Run system-view

     The system view is displayed.

  2. Run wlan

     The WLAN view is displayed.

  3. Run wired-port-profile name profile-name

     An AP wired port profile is created, and the AP wired port profile view is displayed.

     By default, the system provides the AP wired port profile default.

  4. Run mode endpoint

     The working mode of the wired interface is set to endpoint.

  5. Run vlan untagged { vlan-id1 [ to vlan-id2 ] } &<1-10>

     The wired interface is added to one or more VLANs.

  6. Run vlan pvid vlan-id

     A PVID is configured for the wired interface.

  7. Run quit

     Return to the WLAN view.

  8. Bind the AP wired port profile to an AP group or AP.