To prevent STP flapping caused by device restart and peer-link faults and ensure switching performance, you are advised to set the delay in reporting the Up event to be at least 30s on the M-LAG interface, peer-link interface, and other service interfaces. By default, the delay for an M-LAG interface to report the Up state is 120s in V200R005C00 and earlier versions, and 240s in V200R005C10 and later versions.
[DCN]Q&A: What's the default delay time for an M-LAG member interface to report the Up state?
Created: May 21, 2019 03:20:59Latest reply: May 21, 2019 06:38:01
183
3
10
1
- x
- convention：
|
|
|
|
|
|
|
|
|
Comment
Notice: To protect the legitimate rights and interests of you, the community, and third parties, do not release content that may bring legal risks to all parties, including but are not limited to the following:- Politically sensitive content
- Content concerning pornography, gambling, and drug abuse
- Content that may disclose or infringe upon others ' commercial secrets, intellectual properties, including trade marks, copyrights, and patents, and personal privacy
