1. Double confirm again the desire port is in use or not.<?xml:namespace prefix = "o" ns = "urn:schemas-microsoft-com:office:office" />
2. In Fiber/Cable Synchronization, check whether the desire port is found or not.
3. If yes, try resynch it, if no, the desire port is not found proceed into stesp below to fix the issue.
After done all the steps in checking proceed with following,
1. Use Navigator to login into particular NE with the Error issue.
2. Use the command line "cfg-get-fibermgr:0,0,0,0" to list out all the logical fiber connection in that NE
3. A list of logical fiber connection will be display.
"0x00FDEFD 6 11 0x0WFDGRDF 8 4"
(Source Address slot port Sink Address slot port) <<this is what the code means.
<?xml:namespace prefix = "v" ns = "urn:schemas-microsoft-com:vml" />
4. Use command "cfg-del-fibermgr: " to delete desire port.
NOTE: Make sure to get the correct information before proceed to delete the logical fiber.
If the error show is as the Source, then check the source addr, if is sink then check the sink addr.
5. Onces the logical fiber is deleted, the NE on the U200 NMS will show the red arrow logo on the NE icon which incidate changes are suceessfully made and require to synchronize.
6. Proceed to "Synchronize the NE Configuration" to synchronize the NE.
7. Once the NE is synchronized, the logical fiber connection should be able to be created as it needed to be.
