DH321 Compatibility

19

Query the server compatibility on the Huawei Server Compatibility Checker: http://support.huawei.com/onlinetoolsweb/ftca/en

Other related questions:
Default IP address, user name, and password of the X8000 BMC
The X8000 server nodes do not have a default iMana (BMC) IP address. Therefore, it is recommended that the RMC be used to implement centralized management. When using an X8000 server node for the first time, query the iMana management port IP address of the node on the RMC. You can log in to the RMC command line interface using Telnet or SSH, and run the following command to query the iMana management network port IP address, DHCP/static mode, and gateway IP address: rmcget -l blade_id -t eth0 -d info In this command: id indicates the serial number of the server node. The value range is 01a to 40a and 01b to 40b. eth0 indicates the iMana management network port. The default iMana user name and password are as follows: Default user name: root Default password: Huawei12#$

DeviceManager browser compatibility
The browsers supported by DeviceManager vary with operating systems. DeviceManager running on Windows 7 Professional for x86/x64 and Windows Server 2008 R2 Enterprise Edition SP1 for x64 supports the following browsers: Internet Explorer 9 to 11 Firefox 24 to 28 Chrome 27 to 35 DeviceManager running on Mac OS X 10.5 or later versions supports the following browsers: Safari 5.5 to 8.0

RFC 1583 compatibility
Question: Does RFC 1583 compatibility have impact on route selection? Is RFC 1583 compatibility enabled by default? Answer: The rfc1583 compatible command is used to enable the routing selection rule compatible with RFC 1583. After the undo rfc1583 compatible command is executed: If two routes, one in the backbone area and the other in a non-backbone area, direct to the ASBR, the route in the non-backbone area is preferentially selected. If all routes to the ASBR are in non-backbone areas, the route with the lowest cost is preferentially selected. If the routes have the same cost value, the route with the largest area ID has the highest precedence. If the routes to the ASBR are in both backbone area and non-backbone areas, the route with the lowest cost is preferentially selected. If the routes have the same cost value, the route with the largest area ID is preferentially selected. The area ID of the backbone area is 0, so that routes in the backbone area will not be selected. On an S series switch supporting OSPF, RFC 1583 compatibility is enabled by default. If multiple routes exist, the switch selects the route with the lowest cost. If the routes have the same cost value, the switch selects the route with the largest area ID.

Is LLDP compatible with CDP on S series switches
On Huawei S series switches (except the S1700), LLDP is compatible with similar protocols from other vendors to obtain status information about non-Huawei devices. For example, LLDP is compatible with CDP. The configuration procedure is as follows: 1. Enable LLDP globally. [HUAWEI] lldp enable 2. Configure CDP-compatible LLDP on an interface. [HUAWEI] interface GigabitEthernet 0/0/1 [HUAWEI-GigabitEthernet0/0/1] lldp compliance cdp receive

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top