How to Power Off FusionStorage.

3

Stop the FusionStorage service.

Use PuTTY to log in to the active FSM node.
Ensure that the management IP address and user dsware are used to establish the connection.
Run the following command to disable user logout upon system timeout:
TMOUT=0
Run the following command to stop the FusionStorage service:
/opt/dsware/client/bin/dswareTool.sh --op stopDSwareService
Information similar to the following is displayed:
This operation is high risk,please input y to continue:
Enter y as prompted.
Enter username cmdadmin and its password as prompted.
The default password of user cmdadmin is cmdHuawei@123.
The service is successfully stopped if information similar to the following is displayed:
Operation finish successfully. Result Code:0
[Tue May 10 16:16:36 CST 2016] DswareTool operation end.
Power off the virtualization environment or servers.

If FusionStorage is deployed in converged mode, power off the virtualization environment by following operations in the corresponding software documentation. If FusionStorage is deployed in separated mode, power off servers by following operations in the corresponding server documentation.

Other related questions:
How to Power On FusionStorage.
Start the FusionStorage service. Use PuTTY to log in to the active FSM node. Ensure that the management IP address and user dsware are used to establish the connection. Run the following command to disable user logout upon system timeout: TMOUT=0 Run the following command to start the FusionStorage service: /opt/dsware/client/bin/dswareTool.sh --op restartDSwareService Information similar to the following is displayed: This operation is high risk,please input y to continue: Enter y as prompted. Enter username cmdadmin and its password as prompted. The default password of user cmdadmin is cmdHuawei@123. The service is successfully started if information similar to the following is displayed: Operation finish successfully. Result Code:0 [Tue May 10 16:17:23 CST 2016] DswareTool operation end. Start upper-layer services. After FusionStorage is successfully started, start upper-layer services by following operations in the related documents.

How to shut down S series switches
The S series switches (except the S1700) cannot be shut down by running a command. Instead, you can only power off S series switches using the hardware. The procedure is as follows:
1. (Optional) Save the current configuration file of the device.
 <HUAWEI> save
2. Power off the device
a. For S series modular switches, if the device uses pluggable power modules, turn off all the power modules and cut off external power cable.
b. For S series fixed switches, if the device uses built-in power modules, cut off the external power cable. Note that shutting down the device will interrupt services. Exercise caution when performing this operation.

How can I power off the DP300?
To power off the DP300: Tap the power button in the lower right corner of the display twice or turn the power switch on the right panel to OFF.

Powering off an E9000
Power off an E9000 as follows: 1. Power off the blades or switch modules in an E9000 chassis using the MM910 Web interface. For details, see http://support.huawei.com/ehedex/pages/DOC1000053358YEF0907R/08/DOC1000053358YEF0907R/08/resources/en/osca/smma_help_r2/it_osca_smma_900020.html. 2. Disconnect the E9000 power cable from the mains supply.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top