Can Instances That Have Been Added Based on an AS Policy Be Automatically Deleted When They Are Not Required?

14



Yes. They can be automatically deleted if one AS policy has been added to trigger scaling actions to delete them.



Other related questions:
How to delete an applied traffic policy on an S series switch
For S series switches (except the S1700), a traffic policy that is not applied can be deleted directly. To delete a traffic policy that has been applied, unbind the traffic policy and then delete it. Example 1: The traffic policy p1 has been applied in the inbound direction of GE1/0/1. Run the following commands to delete the traffic policy p1: [HUAWEI] interface GigabitEthernet 1/0/1 [HUAWEI-GigabitEthernet1/0/1] undo traffic-policy p1 inbound [HUAWEI-GigabitEthernet1/0/1] quit [HUAWEI] undo traffic policy p1 Example 2: The traffic policy p2 has been applied in the inbound direction of VLAN 100. Run the following commands to delete the traffic policy p2: [HUAWEI] vlan 100 [HUAWEI-vlan100] undo traffic-policy p2 inbound [HUAWEI-vlan100] quit [HUAWEI] undo traffic policy p2 Example 3: The traffic policy p3 has been applied in the inbound direction of the card in slot 6. Run the following commands to delete the traffic policy p3: [HUAWEI] undo traffic-policy p3 global inbound slot 6 [HUAWEI] undo traffic policy p3 Example 4: The traffic policy p4 has been applied in the inbound direction of the system. Run the following commands to delete the traffic policy p4: [HUAWEI] undo traffic-policy p4 global inbound [HUAWEI] undo traffic policy p4 Before deleting a traffic policy, ensure that you have unbound the traffic policy completely. You can run the display traffic-applied command to check information about applied traffic policies. Note: MQC cannot be configured on the S2700SI.

NQA test instance stops automatically
Root cause analysis: By default, no automatic test interval is configured for NQA, that is, the system performs the test only once. The test instance stops automatically after the test is completed. Solution: For the static routes associated with NQA, when the test takes a long time, you need to configure the test frequency. The frequency cannot be set to a small value. Otherwise, the test cannot be completed and there is no NQA test result. It is recommended that this value be configured according to the NQA test type, test time, and other factors. For details, see The NQA test instance is automatically terminated.

Will NICs Added to an ECS Start Automatically?

If the ECS runs CentOS 7.0, NICs added to the ECS cannot start automatically. You must start the NICs manually.


If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top