How to configure the dynamic blacklist function on AC

6

For V200R003 and V200R005, you can perform the following steps on the AC to configure the dynamic blacklist function:
1. Run the dynamic-blacklist enable command in the AP view to enable the dynamic blacklist function.
2. Run the dynamic-blacklist aging-duration duration command in the AP view to set the aging time of the dynamic blacklist. The variable duration specifies the aging time of the dynamic blacklist.
3. Run the commit { all | ap ap-id } command in the WLAN view to deliver configurations to the APs.
For V200R003 and V200R005, you can perform the following steps on Fat APs to configure the dynamic blacklist function:
1. Run the dynamic-blacklist enable command in the WLAN view to enable the dynamic blacklist function.
2. Run the dynamic-blacklist aging-duration duration command in the WLAN view to set the aging time of the dynamic blacklist. The variable duration specifies the aging time of the dynamic blacklist.

Other related questions:
what is the function for blacklist?
the switch will drop all the packets which is matched to blacklist.

Blacklist definition and implementation mechanism of the USG6000 series
The USG6000 series supports configuring the blacklist. The definition and mechanism of a blacklist are as follows: The blacklist is a typical measure for security defense. The system discards all packets that match the blacklist. The blacklist is more efficient in filtering packets from or to specific IP addresses when compared with security policies. The USG6000 series supports blacklisting users, source addresses, or destination addresses to form three types of blacklists. -User blacklist After a user is added to the blacklist, the device discards the packets from or to the user. -Source IP address blacklist After a source IP address is added to the blacklist, the device discards all packets from this IP address. -Destination IP address blacklist After a destination IP address is added to the blacklist, the device discards the packets destined for this IP address.

What is the function of the U1980 blacklist?
After logging in to the U1900, run the following command to add numbers to the calling or called party blacklist or whitelist: config add blackandwhite dn 1000 calltype caller/callee grouptype whitegroup/blackgroup For example, to add 1000 to the called party blacklist, run the config add blackandwhite dn 1000 calltype callee grouptype blackgroup command.

Whether the USG6000 series supports manually deleting a dynamic blacklist
Blacklist entries can be dynamically or manually deleted.

How to configure the WDS function for a WLAN device
Fat APs do not support the WDS function. Currently, the WDS function is supported only in the AC+Fit AP architecture. However, in this architecture, the AP6310SN-GN, AP2010DN, AP2030DN, AP7030DE, AP9330DN, AD9430DN-24 (including connected RUs), and AD9430DN-12 (including connected RUs) do not support the WDS function. In WDS networking, Huawei APs cannot be interconnected to non-Huawei devices. For WDS configuration in the AC+Fit AP architecture, see: V200R005: WDS Configuration. V200R006: WDS Configuration.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top