How to check the IP address of the AR

64

Two modes are available.
Command line mode
-Run the display ip interface brief command to check IP address information on the interface, including the IP address, subnet mask, and status of physical and protocol links.
Run the display ip interface command to check detailed information, including the numbers of received and sent packets, bytes, and multicast packets, and numbers of received, sent, forwarded, and discarded broadcast packets.
-Enter the specified interface view and run the display this command to check the IP address of the interface.
- Web mode:
Log in to the web platform, access wan, find the corresponding interface, for example, Ethernet. Under IPv4 address/submask, you can view the IP address of the corresponding interface.

Other related questions:
How do I check the IP address lease on an AR
On the AR, you can run the following command to check the IP address lease. - If IP addresses are assigned based on the interface address pool, run the display ip pool interface interface-pool-name [ start-ip-address [ end-ip-address ] ] command. - If IP addresses are assigned based on the global address pool, run the display ip pool [ name ip-pool-name [ start-ip-address [ end-ip-address ] ] ] command. The value of the Lease fiels is the lease of the address.

How to check traffic from terminal's IP address on the AR
There is no method to check traffic from terminal's IP address on the AR.

How to view the IP address of the U1900
Log in to the device through the serial cable (serial port rate: 9600). Run the show system information command to view the IP address of the U1900.

How do I check IP addresses that are dynamically obtained by an AR
On the AR, you can run the following command to check the IP address that is dynamically obtained. - If IP addresses are assigned based on the interface address pool, run the display ip pool interface interface-pool-name used command. If the IP addresses are assigned based on the global address pool, run the display ip pool name ip-pool-name used command. You can know the IP address assigned to each client based on the mapping between IP addresses and MAC addresses.

How do I check IP addresses for Internet access on the AR router
1. Run the display nat outbound command to check the outbound NAT configuration and determine the ACL referenced by outbound NAT. 2. Run the display acl { | name | all } command to check the source address in the ACL. The source address is the address segment for Internet access.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top