Do all Huawei APs support Mesh functions

Question: Must all devices on an OSPF NBMA network be fully meshed? Answer: No, devices on an OSPF NBMA network do not need to be fully meshed. For S series switches supporting OSPF, routes between the DR, BDR, and IP addresses of neighbors must be reachable. If the DR is not determined, you can set the priority of a device to 0 and then the device cannot be the DR. To ensure network robustness, you are advised to build a full mesh NBMA network.

All models of switches, except S2700SI support IPSG.

Fat APs do not support the Mesh function. From V200R005C10, the AP9130DN (Fat AP) can function as a vehicle-mounted AP in vehicle-ground communication scenarios. Because vehicle-mounted APs communicate with trackside APs through Mesh links, the Mesh function can be configured for Fat APs since V200R005C10. However, Fat APs can be used only as vehicle-mounted APs in vehicle-ground communication scenarios, but cannot be used for bridging. Currently, the Mesh function is supported only in the AC+Fit AP architecture. However, in this architecture, the AP6310SN-GN, AP2010DN, AP2030DN, AP7030DE, AP9330DN, AD9430DN-24 (including connected RUs), and AD9430DN-12 (including connected RUs) do not support the Mesh function. For more information about Mesh configurations, see: V200R005: Mesh Configuration. V200R006: Mesh Configuration.

Fat APs do not support the Mesh function. From V200R005C10, the AP9130DN (Fat AP) can function as a vehicle-mounted AP in vehicle-ground communication scenarios. Because vehicle-mounted APs communicate with trackside APs through Mesh links, the Mesh function can be configured for Fat APs since V200R005C10. However, Fat APs can be used only as vehicle-mounted APs in vehicle-ground communication scenarios, but cannot be used for bridging. Currently, the Mesh function is supported only in the AC+Fit AP architecture. However, in this architecture, the AP6310SN-GN, AP2010DN, AP2030DN, AP7030DE, AP9330DN, AD9430DN-24 (including connected RUs), and AD9430DN-12 (including connected RUs) do not support the Mesh function. For more information about Mesh configurations, see: V200R005: Mesh Configuration. V200R006: Mesh Configuration.

Fat APs do not support the WDS function. Currently, the WDS function is supported only in the AC+Fit AP architecture. However, in this architecture, the AP6310SN-GN, AP2010DN, AP2030DN, AP7030DE, AP9330DN, AD9430DN-24 (including connected RUs), and AD9430DN-12 (including connected RUs) do not support the WDS function. In WDS networking, Huawei APs cannot be interconnected to non-Huawei devices. For WDS configuration in the AC+Fit AP architecture, see (the R5 version is used as an example): V200R005: WDS Configuration. V200R006: WDS Configuration.