Must a service VLAN be specified for each service set? (V200R005C10 and earlier versions)

9

Each service set corresponds to a VLAN ID. The service set delivers the service VLAN to an AP and delivered Layer data carries the VLAN ID. You must specify a VLAN ID for every service set. The default VLAN ID is 1.

Other related questions:
Must a service VLAN be specified for each service set? (V200R005C10 and earlier versions)
Each service set corresponds to a VLAN ID. The service set delivers the service VLAN to an AP and delivered Layer data carries the VLAN ID. You must specify a VLAN ID for every service set. The default VLAN ID is 1.

WLAN service set
WLAN service set A wireless network consists of radio profiles and service sets. - A radio profile contains WMM (QoS) profiles. - A service set contains traffic and security profiles, SSIDs, and WLAN-ESS/WLAN-BSS interfaces (wireless air interfaces). Service VLANs must be configured on ACs. - The wireless air interface is the logical interface for APs to connect to a STA. Typically, the wireless air interface is configured to work in hybrid mode.

How do I replace a faulty aP to accelerate service recovery? (V200R005 and earlier versions)
To replace the AP that associates with an AC with a new AP without reconfiguring data for the new AP, run the ap modify command in WLAN view to change the MAC address and serial number (SN) of the faulty AP to those of the new AP. The new AP must be of the same type as the faulty AP. After the modification, the new AP with the ID of the previous AP re-associates with the AC and inherits all the data configured on the previous AP.

Configure the service VLAN and management VLAN
Configure the service VLAN and management VLAN. 1. Service VLAN - Command output on the AC: [HUAWEI]wlan [HUAWEI-wlan-view]service-set name test [HUAWEI-wlan-service-set-test]service-vlan 100 Multiple service sets have access to different service VLANs. 2. Management VLAN - Configure PVID and untag for the management VLAN on the switch connected to the AP. Allow packets from the management VLAN to pass through. - On Fit APs, no configuration is required for the interfaces connected to the switch. - On Fat APs, the configurations for wired-side interfaces are the same as the configurations for the interfaces on the switch. Note: 1. It is recommended that you configure the service VLAN and management VLAN differently, and do not use VLAN 1 for both VLANs. 2. In normal cases, there is only one management VLAN, but multiple service VLANs can be configured as required. 3. A service set can contain only one service VLAN. 4. In tunnel forwarding, the switch between the AP and AC does not allow packets from service VLANs to pass through, but in direct forwarding, the switch must allow packets to pass through. 5. If the service VLAN or management VLAN is changed, VLAN configurations on the devices along the path must be modified. If the network is newly deployed, you are advised to dial 400-822-9999 to seek assistance from Huawei's presale team to perform the network planning first.

Whether the open service component must be installed
The open service component must be installed.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top