How do I delete the configuration on a specified interface of a WLAN device

7

To delete all configurations on a specified interface of a WLAN device, you need to delete the configurations one by one.
For example, if GE0/0/1 works in auto-negotiation mode and automatically negotiates both the rate and the duplex mode, run the following commands to delete corresponding configurations:
- Run the undo auto duplex command in the interface view to restore the default duplex mode for the Ethernet electrical interface in auto-negotiation mode.
- Run the undo auto speed command in the interface view to restore the default negotiation rate for the Ethernet electrical interface in auto-negotiation mode.

Other related questions:
How to specify the configuration file for next startup on a WLAN device
Run the following commands in the user view on a WLAN device (except Fit APs) to specify the configuration file for next startup: - Run the startup system-software command in the user view to specify the system software for next startup. - Run the startup saved-configuration command in the user view to specify the configuration file for next startup. The following takes newbasicsoft.cc (system software for next startup) and vrpcfg.zip (configuration file) as an example: # Specify the system software to be loaded for the next startup. startup system-software newbasicsoft.cc # Specify the configuration file to be loaded for the next startup. startup saved-configuration vrpcfg.zip

Blocking a specified interface on a WLAN device using STP
You can use one of the following methods to block a specified interface on a WLAN device: 1. Run the stp priority command to set the device priority. 2. Run the stp cost command to set the path cost of the interface. 3. Run the stp port priority command to set the interface priority.

Configuring hybrid interfaces on WLAN devices
The following example describes how to configure a hybrid interface on a WLAN device: - A hybrid interface can connect to either a user device or a switch. [HUAWEI]vlan 2 //Create a VLAN. [HUAWEI-vlan2]quit [HUAWEI]interface gigabitethernet0/0/2 [HUAWEI-GigabitEthernet0/0/2]port link-type hybrid //Set the interface type to hybrid. [HUAWEI-GigabitEthernet0/0/2]port hybrid untagged vlan 2 //Configure the interface to allow packets from VLAN 2 to pass through in untagged mode. [HUAWEI-GigabitEthernet0/0/2]port hybrid pvid vlan 2 //(Optional) Specify VLAN 2 as the default VLAN of the interface (default: VLAN 1). [HUAWEI-GigabitEthernet0/0/2]port hybrid tagged vlan 3 //Configure the interface to allow packets from VLAN 3 to pass through in tagged mode.

How can I delete patches from a WLAN device
Run the following command to delete patches from a WLAN device: patch delete all //Delete all patches. Delete patches when the following situations occur: - If you find errors in patches that have been loaded to the system, run this command to delete the patches to prevent patch errors from affecting system operating. - If the patch installation fails and a rollback procedure is necessary, run this command to delete all patches.

Configuring access interfaces on WLAN devices
The following example describes how to configure an access interface on a WLAN device: An access interface can connect to a user host. [HUAWEI]vlan batch 2 //Create a VLAN. [HUAWEI]interface gigabitethernet0/0/1 [HUAWEI-GigabitEthernet0/0/1]port link-type access //Set the interface type to access. [HUAWEI-GigabitEthernet0/0/1]port default vlan 2 //Add the interface to VLAN 2. [HUAWEI-GigabitEthernet0/0/1]quit

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top