Switch between the wired and wireless sides on the AC

27

An AC6605 in V200R002 or earlier has both wired and wireless sides.
You cannot perform WLAN-related commands on the wired side or configure wired interfaces on the wireless side.

By default, you log in to the wired side of the AC6605.
- Run the console switch command or press Ctrl+Y to switch the AC to the wireless side.
- You must log in to the AC through the console port to switch between the wired and wireless sides. You can run the console switch command only after logging in to the CLI, whereas you can press Ctrl+Y even if you have not logged in to the CLI.

To log in to an AC using Telnet, enter the IP address of the wired side or wireless side.

Other related questions:
WLAN security of AR routers
WLAN security is as follows: User access security: Link authentication, access authentication, and data encryption are used to ensure validity and security of user access on wireless networks. Service security: This feature protects service data of authorized user from being intercepted by unauthorized users during transmission. For details, see WLAN Security Configuration.

Configuration of an AP's wired interfaces
Configuration of a Fit AP's wired interfaces: For V200R005: [HUAWEI]wlan [HUAWEI-wlan-view]ap id 0 [HUAWEI-wlan-ap-0]lineate-port Ethernet 0 pvid vlan 100 [HUAWEI-wlan-ap-0]lineate-port Ethernet 0 vlan untagged 100 The preceding configuration takes VLAN 100 as an example. An AP's wired interfaces can be used to connect wired terminals. For V200R006: [HUAWEI]wlan [HUAWEI-wlan-view]wired-port-profile name profile-name //Create an AP wired port profile, and configure wired interface parameters in the profile. Note: 1. If an AP is connected to a switch, you can configure VLANs to allow their packets to pass through. 2. Some APs have two or more wired interfaces. The serial number of a wired interface starts with 0 and is incremented.

SNMP configuration on S series switch
S series switches (except S1700 switches) support three SNMP versions: SNMPv1, SNMPv2c, and SNMPv3. SNMPv1 and SNMPv2c use community names for authentication, resulting in low security, whereas SNMPv3 uses authentication and encryption technologies to enhance security. The following uses SNMPv2c configuration as an example: [HUAWEI] snmp-agent //Enable SNMP. [HUAWEI] snmp-agent sys-info version v2c //Set the SNMP version to SNMPv2c. [HUAWEI] snmp-agent community write adminnms01 //Set the SNMP write community name. For common SNMP configuration information, see "Common SNMP Operations" in S1720&S2700&S3700&S5700&S6700&S7700&S9700 Series Switches Common Operation Guide. For typical SNMP configuration examples, see "Typical SNMP Configuration" in "Typical Network Management and Monitoring Configuration" of S1720&S2700&S3700&S5700&S6700&S7700&S9700 Typical Configuration Examples. Common configuration and typical configuration examples for S9300 and S12700 series switches are the same as those for Sx700 series switches. The Sx700 series switches are used as an example here.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top