Why is the association rate displayed on wireless terminals low

21

- This is because wireless terminals are far away from APs. As a result, radio signals are weak. In this case, the association rate that is negotiated by the wireless terminals is low. Specifically, the signal transmission rate of 802.11g APs includes 54

Other related questions:
Why is the association rate displayed on the STA low
The possible causes for the low association rate displayed on the STA include: - If the STA is far away from the AP, signals are weak, and the negotiated association rate of the STA is low. - If the 802.11n APs use WEP or TKIP encryption, the association rate of STAs may only be 54 Mbit/s (that is the rate of 802.11b/g). Because WEP and TKIP are not defined in the 802.11n protocol, the STA associates with the AP in 802.11g mode if TKIP encryption is used. - If the network adapter supporting only the 802.11b/g mode is associated with the 802.11n AP, the maximum associated rate is 54 Mbit/s. Alternatively, the radio type configured on the 802.11n AP is in 802.11b/g mode, so the AP supports only the radios in 802.11b/g mode. Try the following methods to resolve the problem: 1. Place the STA closer to the AP. 2. Change the encryption mode to CCMP in the security profile.

Wavelength recommendations for low-rate and high-rate services
For optical-layer ASON, shorter wavelengths are recommended for low-rate services, and longer wavelengths are recommended for high-rate services. This ensures better performance for optical-layer services.

When the wireless terminal pings the gateway, packet loss occurs
You can run the dtim-interval 1 and beacon-interval 100 commands in the specified radio profile to configure the DTIM interval and Beacon interval.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top