Port working mode used by the TOA board to receive OC-48 services

11

The TOA board uses the ODU1 non-convergence mode to receive OC-48 services.

Other related questions:
Working mode of the TOA board when ODU0 services are configured on the board
When ODU0 services are configured, the working mode of the TOA board must be set to ODU0 non-convergence mode (Any -> ODU0).

Method used to set the Ethernet working mode of a GE port on the TOA board
Ethernet Working Mode can be set to Auto-Negotiation or 1000M Full-Duplex. The default value is 1000M Full-Duplex. Auto-Negotiation can automatically determine the optimal working modes of the interconnected ports. This mode facilitates maintenance. Ethernet Working Mode is valid only when the service type is set to GE (TTT-GMP). The Ethernet working mode must be consistent with the setting for upstream services. Two ports that are mutually protected in active-standby mode must have the same Ethernet Working Mode setting.

Whether the TOA board can receive eight 2.5G services
The TOA board supports conversion between eight signals at a rate ranging from 125 Mbit/s to 2.5 Gbit/s and eight ODU1 signals.

Whether the OSN 8800 TOA board can receive eight 2.5G services
The TOA board can perform mutual conversion between eight ODU1 electrical signals and eight optical signals at rates ranging from 1.49 Gbit/s to 2.67 Gbit/s.

Working mode setting for an ELOM board to receive GE services on OSN 1800
1 x AP8 ODU0 non-aggregation mode can be selected.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top