Method used to handle the error message indicating a service conflict during service configuration on the OSN 8800

2

Delete discrete services.

Other related questions:
Method used to handle the error message displayed indicating a mismatch between the created service board and the existing service board during logical board addition for the TOA board (error code 44062)
Verify that cross-connect boards are configured.

Method used to handle the error message displayed indicating a mismatch between the cross-connect board and service board during logical board addition for the TOM board (error code 44061)
If the TOM board is a TN11TOM board, it cannot be used on the OSN 8800. You are advised to replace it with a TN52TOM board.

Method used to handle the error message indicating a mismatch between the working channel overhead setting and protection group layer (error code: 41907) during SNCP configuration on the OSN 6800
Verify that the non-intrusive monitoring at the PM layer of the line board is enabled.

Method used to handle the conflict between two services with the same wavelength at the ROADM site
If two services with the same wavelength conflict at the ROADM site, they will be carried over two different wavelengths after being rerouted. This process has no impact on the services.

Method used to map client-side services into ODUk signals on the OSN 8800
The OSN 8800 can map client-side services into ODUk signals in two modes: standard and timeslot. In standard mode, the OSN 8800 directly maps client-side services into ODUk signals to achieve flexible service scheduling. In timeslot mode, the OSN 8800 converges multiple services whose rates are lower than 1.25 Gbit/s into one ODU0 or converges services whose rates are lower than 2.5 Gbit/s into one ODU1. In this way, multiple services share the same ODU0 or ODU1 bandwidth.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top