Entry for setting the client-side service type for the LDGF and TN52TOM boards

3

You can set the client-side service types for LDGF and TN52TOM boards in WDM Interface in the NE Explorer on the NMS.

Other related questions:
Types of services received on the client side of the TOG board
The type of the client-side service on the TOG board is GE Ethernet, and the service rate is 1.25 Gbit/s.

Types of services that can be received at the client side of the LSX board
The LSX board supports the following types of services: 10GE LAN: Ethernet service at a rate of 10.31 Gbit/s 10GE WAN: Ethernet service at a rate of 9.95 Gbit/s STM-64/OC-192: SDH/SONET service at a rate of 9.95 Gbit/s OTU2: OTN service at a rate of 10.71 Gbit/s OTU2e: OTN service at a rate of 11.1 Gbit/s (supported only by TN13LSX/TN14LSX) FC1200: SAN service at a rate of 10.51 Gbit/s (supported only by TN12LSX/TN13LSX/TN14LSX)

Client-side service type for OTN service boards when 10GE WAN services are received
When 10GE WAN services are received, the client-side service type for OTN service boards must be 10GE WAN or STM-64.

Differences between the RX1/TX1 and RX2/TX2 ports on the LDGF board and whether the two ports transmit services using the same channel
The LDG2 board has two client-side ports: RX1/TX1 and RX2/TX2. The two ports are GE ports and use the same channel to transmit services.

Method used to configure services on the TN52TOM board
The procedure for configuring services on the TN52TOM board is as follows: 1. Configure the working mode of the TN52TOM board and the working mode of its ports. 2. Set the service type of its LP port. 3. Create a service from a physical port to an LP port. 4. Create a service from its LP port to a line board.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top